Who is this article for?
CrashPlan for Enterprise, yes.
Code42 for Enterprise, yes.
CrashPlan for Small Business, no.
This article applies to on-premises authority servers.
Your M1 or S2 Code42 managed appliance indicates its status with LED indicator lights. The LEDs indicate the power state of the managed appliance, which drives are active, which are bad or failed, and other activities. This guide acts as a key to those status indicators.
Model M1 and S2 managed appliances
Hard drive LEDs
The indicator lights on the drive carriers in managed appliances reveal the status of each individual drive. Each drive carrier has two LEDs: an activity LED (green) and a status LED (bicolor, green/amber). The activity LED flashes whenever the drive is accessed.
The table below contains descriptions of the LED light patterns for the status LED.
|LED Color||LED Display||Description|
|No light||Off||Slot is empty or the drive has not been discovered by the system.|
|Green||Steady green||Normal activity.|
|Green||Green flashing (250 ms)||Drive is being identified or is being prepared for removal.|
|Green||Green flashing (On 400 ms, Off 100 ms)||Drive is rebuilding or undergoing a Replace Member operation.|
|Amber||Amber flashing (125 ms)||Drive has failed.|
|Green/amber flashing (Green On 500 ms / Amber On 500 ms, Off 1000 ms)||Predicted failure reported by drive.|
|Green/amber alternating (Green On 3000 ms, Off 3000 ms, Amber On 3000 ms, Off 3000 ms)||Drive powering down by user request or other non-failure condition.|
Power supply LEDs
The LED indicator light for the power supply is enclosed in its handle. See the table below for the status of the power supply.
|No light||Power supply is not working or not powered on.|
|Solid green||Power supply is functioning normally.|
|Blink amber||Fault detected.|
|Blink green||Firmware update.|
|Blink green and off||Power supply mismatch.|
The managed appliance chassis has different indicators depending on the model. The M1 has an LCD display with text-based error codes. The S2 has LED indicators to reveal the status of the chassis.
The LCD will display blue when there are no errors, or amber when in an error state.
|PDR0001||Fault detected on drive <number>.||The controller detected a failure on the disk and took the drive offline.||Remove and reseat the failed disk.|
|PDR1016||Drive <number> is removed from disk drive bay <bay number>.||The controller detected that the drive was removed.||Verify drive installation and reseat the drive.|
For information on other errors, please contact our Customer Champions for support.
|Green||Normal hard drive activity with no errors.|
Error, displayed with additional icon.
|Temperature, fan, or heatsink errors.|
|Voltage or power supply errors.|
|PCI card errors.|